Advertisement
For detailed information see technical datasheet "76 - Fillers"
For detailed information see chapter / section "Sanding and Cleaning"
Addition of hardeners
(A665, A666, A667)
Application: use a suitable knife or spreader. Apply one or more coats as necessary, allowing 5 –
10 minutes at 20°C between coats. Galvaplast 77 can be used directly on the bare metal.
Dry to sand:
from °C to 10°C
from 10 °C to 20 °C
from °C to 30°C
IR medium
IR short
Dry sanding paper grades:
Overcoating at 20° C:
for detailed information see chapter / section "Sanding and Cleaning".
For detailed information see technical datasheet "10 – Universel D831"
For detailed information see chapter / section "Sanding and Cleaning"
Mixing Ratio
* For exceptional conditions of temperature and humidity (> 35°C / > 70%) and for
large areas use Slow Reactive Thinner D833
Number of coats: 2-3
Flash-off between coats at 20°C: 5 minutes
Drying times:
Dustfree
Dry to sand at 20°C
Dry to sand at 35°C
Total dry film build: 15 - 20 µm
Repair / Recoating:
from °C to 10°C
from 10 °C to 20 °C
from °C to 30°C
25 – 35 minutes
20 – 30 minutes
15 – 20 minutes
5 – 6 minutes
4 – 5 minutes
P80 - P120 - P240
30 minutes
Deltron D831 – Universel
D831
D832 / D833 *
5 minutes
30 - 45 minutes (D832)
30 - 45 minutes (D833)
with P400 (dry), if necessary
Overcoat / Re-coat time at
at 20°C (airdrying): 30 – 40 minutes
2,5 % - 3,0 %
from ,0°C to 2,5°C
from ,5°C to 2,0°C
(by weight)
1 vol
1 vol
Advertisement
