Advertisement
The vehicle is equipped with a manual system for releasing the Park Lock for use in the event of an
emergency (e.g. vehicle breakdown or when transporting the vehicle with the battery disconnected).
The system allows the Park Lock to be released from either the passenger compartment (UP TO Assembly
No. 85744) or the luggage compartment. The device uses 4 Bowden cables with INOX laminated sheath
and internal teflon sheath for heat protection, connected to a device mounted on the DCT gearbox, in
particular on the release pin. Two cables are mounted on the underbody, two are mounted on the DCT
gearbox/underchassis.
Deactivating Park Lock electronically (CAR WASH mode)
CAUTION
The vehicle may move with no warning when the Park Lock is released electronically (CAR WASH mode)!
The vehicle is held in position only by the electric parking brake, if engaged.
At each Key-OFF, the Park Lock system engages automatically to prevent the vehicle from moving.
Provided that the vehicle electrical system is functioning correctly, the Park Lock system may be deactivated
electronically as described as follows.
In the case of a vehicle electrical system malfunction, the Park Lock system must be released with
the "Emergency mechanical release procedure for Park Lock".
Start the engine.
Select 1st gear.
Select neutral (N).
Switch off the engine.
Turn the ignition switch to Key-ON within 3 seconds.
Advertisement
