Advertisement
Apply the fastener screws for the Tonneau Cover complete with kinematics, after fitting the relative
washers, maintaining the original position.
Follow the instructions for correctly refitting the screws retrieved during removing.
CAUTION
Danger of accident! At least two operators are required to manually move the components of the RHT roof,
working slowly and in a coordinated fashion.
When handling the tonneau cover manually, the tonneau cover fastener latches may damage the
blocks fastened to the kinematics of the tonneau cover.
The blocks fastened to the kinematics of the tonneau cover protect the flaps. As a result, damage to
the blocks will also result in damage to the flaps.
Before handling the tonneau cover manually, check that the latches fastening the tonneau cover are
correctly released.
Manually close the Tonneau Cover completely.
Tighten the front fastener screw (10) for the left
hand Tonneau Cover kinematics (B).
Tightening torque
M10x75 screw
Tighten the front fastener screw (9) for the right
hand Tonneau Cover kinematics (A).
Tightening torque
M10x75 screw
Nm
Class
43 Nm
B
Nm
Class
43 Nm
B
Advertisement
