Advertisement
Refit the wheels (
Connect the battery (
Removing the rear wheel ABS sensor
Disconnect the battery (
Remove the wheels (
D2.01).
F2.01).
F2.01).
D2.01).
Fit the indicated cable grommets for the ABS
sensor cable (A) onto the mounting bracket.
Slide connector (2) of ABS sensor cable above
brake pad wear sensor and connect it.
Attach cable grommet (1) of ABS sensor cable to
the relevant mounting bracket.
Connect brake pad wear sensor cable to the
cable grommet (1).
Check that the indicated clip is located 50 - 60
mm away from the cable grommet (1).
Connect ground cable to the indicated clip.
Tighten new cable ties in the positions indicated.
Cut the three new clamps indicated fastening the
ABS sensor cable (A) to the ground cable
and to the brake pad wear sensor cable.
Remove the cable grommets (2) for the ABS
sensor cable (A) from the mounting brackets
on the chassis, then detach the relative
connector (1).
Advertisement
