Advertisement
E6.11
Striker plates and receivers
Replacing the Rear Roof shell striker plates on the Tonneau Cover
CAUTION
If the RHT open or close cycle is not completed, the hydraulic system remains pressurised for up to 5
minutes after the control button is released. After this period, the system emits a warning sound to warn
the driver and any persons in the vicinity that the system is no longer pressurised and that components of
the RHT system may drop without warning.
The Rear Roof shell striker plates are located at the front of the Tonneau Cover.
The following procedure is for replacing the left hand striker plate.
Except where indicated otherwise, the procedure for replacing the right hand striker plate is identical.
To prevent damage to the vehicle, ensure
that the Rear Roof shell fastener hooks
are completely and correctly opened
before operating the RHT roof electrically.
Operate the RHT roof electrically to open the
Tonneau Cover completely.
Right hand striker plate
Undo the screw fastening the sensor (A) to the
striker plate.
Remove the sensor (A) from the relevant seat on
the striker plate.
Advertisement
