Advertisement
Check the correct alignment between the pin of the Rear Roof shell striker plate and the Tonneau
Cover receiver.
Refit the passenger compartment trim panels (
Refit the upper lateral trim panel.
Adjusting the Rear Roof shell striker plates on the Tonneau Cover
Tightening torque
Rear Roof shell striker plates - Tonneau Cover
Tonneau Cover receivers - mounting bracket
CAUTION
If the RHT open or close cycle is not completed, the hydraulic system remains pressurised for up to 5
minutes after the control button is released. After this period, the system emits a warning sound to warn
the driver and any persons in the vicinity that the system is no longer pressurised and that components of
the RHT system may drop without warning.
The Rear Roof shell striker plates are located at the front of the Tonneau Cover.
The following procedure is for adjusting the right hand striker plate.
The procedure for adjusting the left hand striker plate is identical.
Remove the passenger compartment trim panels (
Remove the upper lateral trim panel, leaving the seat belts attached.
Connect a stabilised battery charger to the vehicle.
E4.04).
M6x25 Screw
M6x16 Screw
E4.04).
To carry this procedure out correctly, the axis
must be oriented as indicated in the figure
aside.
Nm
Class
8 Nm
B
9 Nm
A
Advertisement
