Advertisement
E6.05
Rear panel
Removing the Rear Roof shell
If the Front Roof shell has already been removed, fit the specific Front Roof shell kinematics connector
tool to maintain the preload and alignment of the kinematics.
The following is the Rear Roof shell removal procedure for the right-hand side of the vehicle; repeat the
procedure on the left-hand side of the vehicle.
Remove the RHT headliner elements (
Remove only the upper and lower rear screen trim panels and the RH and LH tensioner cables of the
rear roof shell.
Lower the door windows and quarterlights completely.
Open the luggage compartment lid, turning the key in the relative lock.
Disconnect the battery (
E6.03).
F2.01).
CAUTION
Danger of accident! At least two operators are
required to manually move the components of
the RHT roof, working slowly and in a
coordinated fashion.
Electrically bring the RHT into the intermediate
position, with the Rear Roof shell over the
Front Roof shell and with the Tonneau Cover
completely opened.
Remove the rod
(AV
tape (8) to mark the original position of the
two bumpers (M).
Loosen the four dowels indicated fastening the
two bumpers (M).
Move the two bumpers (M) towards the ends of
the rod
(AV
8178).
Tighten the four dowels indicated fastening the
two bumpers (M).
8178) and use adhesive
Advertisement
