Advertisement
DG
HS-Hardener
Thinner
Number of coats: 2-3
Flash-off between coats at 20°C: 10 – 15 minutes
Flash-off before stoving at 20°C: 10 – 15 minutes
Drying times:
Dustfree at 20°C
Touch dry at 20°C
Through dry at 20°C
Through dry at 60°C
Through dry (IR)
Total dry film build: 70 – 110 µm (tinted: 60 – 90 µm)
Sand with P400 (dry) or P800 (wet)
Deltron BC
Deltron D8105
Deltron BC
Deltron D8109
Notes:
-
D8105 can be replaced by D8109 if the Fade-out technique is required .
- The following system is required if on the car the Colour Code label indicates "WATERBORNE
TECHNOLOGY".
-
If a damaged part has to be repaired without replacing it, it is absolutely necessary to sand the OE
Clear thoroughly. Superficial sanding can result in adhesion problems.
-
Panel repair - also of adjacent parts – is recommended for optimum scratch resistance!
CeramiClearTM warranty repair system, conventional with sanding,for Aluminium substrates, total or partly
respray, for stonechipping areas and tintable surfacer.
Cleaning / Sanding
Primer
Surfacer (if polyester filler is
necessary)
Putty / Filler (If necessary)
Surfacer
Basecoat(s)
1 vol
1 vol
1 vol
Approved Topcoats to be used with this Repair System
see technical datasheet "02 – Deltron BC"
see technical datasheet "170 – Deltron D8105"
see technical datasheet "02 – Deltron BC"
see technical datasheet "171 – Deltron D8109"
Substrates
Aluminium / Magnesium
see below
Universal D831
Deltron D821 HS
Galvaplast 77
Deltron D821 HS
Deltron BC
DG
MS-Hardener
Thinner
35 minutes
1,5 - 2 hours (tinted: 2 – 2.5 hours)
Overnight
20 – 25 minutes; tinted: 30
minutes (metal temperature)
10 - 15 min
1 vol
1,5 vol
1 vol
Advertisement
