Advertisement
Fit the Rear Roof shell (A) in the relative seat on
the kinematics. If refitting the original
component, use the markings made during
disassembly as reference.
With shims installed on the outer screw (2), fit
the shims on the kinematics before fitting
the Rear Roof shell.
Hand tighten the two fastener screws (3), fitting
any shims necessary.
When refitting the same Rear Roof shell, use
the original shims.
When fitting a new Rear Roof shell, reuse the
original shims as an initial guideline.
Hand tighten the two fastener screws (3)
CAUTION
Danger of accident! At least two operators are
required to manually move the components of
the RHT roof, working slowly and in a
coordinated fashion.
Manually move the Rear Roof shell (A) toward
the rear of the vehicle.
Lock the Rear Roof shell kinematics in the safety
position, fitting the relative rod
Hand tighten the fastener screws (2)
CAUTION
Danger of accident! At least two operators are
required to manually move the components of
the RHT roof, working slowly and in a
coordinated fashion.
The following operation is extremely
important in order to preserve the correct
preload and alignment of the linkages of
the Front Roof shell kinematics. When
removing the Rear Roof shell fasteners,
the Front Roof shell kinematics must be
in Coupé configuration.
Hold up the Rear Roof shell (A) and remove the
rod
(AV
8178) fitted previously.
Manually move the rear roof shell (A) toward the
rear of the vehicle, so that it is over the
tonneau cover.
(AV
8178).
Advertisement
