Advertisement
E6.02
Complete retractable hard top
Removing the complete retractable hard top (RHT assembly)
CAUTION
Danger of accident! At least two operators are required to manually move the components of the RHT roof,
working slowly and in a coordinated fashion.
Before removing any fastener clamps and/or clips in the electronic system and/or hydraulic system,
note the number and position of the components to ensure that they are refitted correctly during
reassembly.
The following procedure is for removing the complete RHT from the vehicle. The complete RHT consists of
the "RHT assembly" (the two panels, the roof kinematics and the entire hydraulic and electrical systems)
and the Tonneau Cover with relative kinematics.
To carry out the procedure correctly, a hoist, the specific lifting hook and the relative support arms for the roof
kinematics are necessary.
Note that the electrical system cables and the hydraulic RHT system pipes are covered in protective material.
Remove the luggage compartment trim panels (
Remove the luggage compartment lid (
Carry out the operation leaving the hinges fastened to the Tonneau Cover.
Remove the RHT hydraulic system pump (
Leave connected to the hydraulic system and set down safely in the centre of the luggage
compartment.
Replace the Tonneau Cover hydraulic cylinders (
Carry out the procedure for removal ONLY, leaving connected to the hydraulic system.
Remove the DCT gearbox ECU (
CAUTION
Danger of accident! At least two operators are required to manually move the components of the RHT roof,
working slowly and in a coordinated fashion.
Manually bring the Rear Roof shell into the intermediate position, with the Rear Roof shell over the Front
Roof shell and with the Tonneau Cover completely opened.
E4.07).
E3.02).
E6.12).
E6.12).
F2.11).
Advertisement
