Advertisement
CAUTION
If the RHT open or close cycle is not completed,
the hydraulic system remains pressurised for
up to 5 minutes after the control button is
released. After this period, the system emits a
warning sound to warn the driver and any
persons in the vicinity that the system is no
longer pressurised and that components of the
RHT system may drop without warning.
Electrically bring the RHT into the intermediate
position, with the Rear Roof shell over the
Front Roof shell and with the Tonneau Cover
completely opened.
Remove the rod
(AV
tape (8) to mark the original position of the
two bumpers (M).
Loosen the four dowels indicated fastening the
two bumpers (M).
Move the two bumpers (M) towards the ends of
the rod
(AV
8178).
Tighten the four dowels indicated fastening the
two bumpers (M).
CAUTION
Danger of accident! At least two operators are
required to manually move the components of
the RHT roof, working slowly and in a
coordinated fashion.
Move the Rear Roof shell by hand toward the
rear of the vehicle.
Lock the Rear Roof shell kinematics in the safety
position, fitting the special rod
shown in the image aside.
8178) and use adhesive
(AV
8178) as
Advertisement
