Advertisement
"Scheduled Maintenance" reset
At every scheduled service date, the 'maintenance complete' procedure must be performed using the relative
function on the DEIS diagnostic tester.
The instrument panel must store the following data:
service No. performed;
service date;
total mileage at service date.
This data must be readable via the DEIS diagnostic tester.
At each service, before resetting the "Scheduled Maintenance" parameter, the instrument panel verifies that
the date on the CAN network is later than the "start of vehicle life" date or that of the previous service. If
these conditions are not met, the panel will not accept the reset operation.
External temperature
The temperature is shown permanently in the relative display area A3.
EXTERNAL TEMPERATURE is shown in full sized format with a resolution of 1 °C or 1 °F (depending on
preferences in set-up menu), with no decimals.
Temperature display in either Centigrade or Fahrenheit is selectable from the menu (on NIT, with the set-up
menu available).
The parameter may temporarily be obscured by specific messages (the area of the display occupied is
Advertisement
