Advertisement
Clearcoat(s)
for detailed information see chapter / section "Sanding and Cleaning".
Cleaning
Clean any old paint (OE finish) thoroughly with water first to remove any water soluble dirt.
Clean with a suitable pre-cleaner, e.g. D837 (DX330) Spirit Wipe o D845 (DX310) High
Strength Degreaser. If there is any VOC legislation in force, use D8401 Waterborne low VOC
Cleaner.
Dry Sanding (rotary-orbital machine)
Use the following paper grades depending on the substrate. Use a guide coat for best results:
Aluminium /
Magnesium
OE Finish / Repair
Coatings
Wet Sanding (manual)
Do not wet sand
Cleaning
Clean with a suitable pre-cleaner, e.g. D837 DX330 Spirit Wipe o D845 DX310 High Strength
Degreaser. If there is any VOC legislation in force, use D8401 Waterborne low VOC Cleaner.
Overcoat any exposed Aluminium within 4 hours.
for detailed information see chapter / section "Sanding and Cleaning".
For detailed information see technical datasheet "10 – Universel D831"
For detailed information see chapter / section "Sanding and Cleaning"
Mixing Ratio
* For exceptional conditions of temperature and humidity (> 35°C / > 70%) and for
large areas use Slow Reactive Thinner D833
Number of coats: 2-3
Flash-off between coats at 20°C: 5 minutes
Drying times:
Dustfree
Dry to sand at 20°C
Dry to sand at 35°C
Total dry film build: 15 - 20 µm
Deltron D8105, Deltron D8109
Substrate Preparation and Cleaning
P150 - P220, 3M Scotch-Brite ™ red pad,
3M Soft Pad superfine
P240 - P400, 3M Scotch-Brite ™ red pad,
3M Soft Pad superfine
Deltron D831 – Universel
D831
D832 / D833 *
1 vol
1 vol
5 minutes
30 - 45 minutes (D832)
30 - 45 minutes (D833)
Advertisement
