Advertisement
Adjust the Rear Roof shell striker plates on the Tonneau Cover (
Replacing Tonneau Cover receivers
Remove the passenger compartment trim panels (
Remove the upper lateral trim panel.
Adjust the Rear Roof shell striker plates on the Tonneau Cover (
Undo the two screws indicated fastening the
striker plate (B) to the Tonneau Cover.
Remove the striker plate (B) from the relevant
seat on the Tonneau Cover, recovering the
relevant shims, and replace.
Fit the new striker plate (B) in the relevant seat
on the Tonneau Cover, installing the relevant
shims.
Loosely tighten the two screws indicated
fastening the striker plate (B) to the Tonneau
Cover.
Right hand striker plate
Fit the sensor (A) in the relevant seat on the
striker plate.
Tighten the screw fastening the sensor (A) to the
striker plate.
E6.11).
E4.04).
Undo the indicated screws, retrieving the
washers.
Remove the receiver (A) and replace.
Fit the new receiver (A).
Tighten the indicated screws, repositioning the
washers.
E6.11).
Advertisement
