Advertisement
Connect the battery (
F2.01).
CAUTION
Two operators are needed to carry out this
operation.
Raise the left side of the Tonneau Cover so as to
gain access to sensor (A).
Undo the indicated screw.
Remove the sensor (A) and replace.
Fit the new sensor (A).
Check that the magneto is clean and free of
metal dust.
Hand tighten the indicated screw.
CAUTION
Two operators are needed to carry out this
operation.
Lower the left hand side of the Tonneau Cover.
NEVER touch the pins with your bare hands,
as this may damage the pins themselves.
Wear appropriate gloves.
Connect pins (5) to connector (3).
Referring to the pin colours and locations noted
previously, connect the pins (5) correctly.
Position and insert safety catch (4).
Connect the connector (3).
Tighten the screws (2).
Connect cable ties (1).
Tighten new cable ties in the positions indicated.
Advertisement
