Advertisement
On vehicles with mechanical gearbox, the signalling occurs with the display of a small "arrow" on the upper
right-hand side of the DOT MATRIX display which can be stationary or flashing (3Hz d.c.50%) depending
on the value of the signal received.
The arrow symbol appears to indicate the recommended time to upshift at the lowest speed possible
(sustainable by the vehicle in each gear) to reduce fuel consumption.
Replacing the instrument panel
Tightening torque
Fastening instrument panel - binnacle
The trim panel is located on the left-hand side of the dashboard.
Disconnect the battery (
Remove the binnacle (
Refit the binnacle (
Connect the battery (
Connect the DEIS tester to the diagnostic socket (
F2.01).
E4.02).
E4.02).
F2.01).
Screw
Undo the two screws indicated fastening the
instrument panel (B) to the binnacle (A).
Remove the instrument panel (B) from the
binnacle (A) and replace.
Fit the new instrument panel (B) on the binnacle
(A).
Tighten the two screws indicated fastening the
instrument panel (B) to the binnacle (A).
Tightening torque
Screw
F2.10).
Nm
Class
2.6 Nm
B
Nm
Class
2.6 Nm
B
Advertisement
