Advertisement
After the roof has completed the open or close cycle (completely open / completely closed), the TFT display
displays the specific message "Roof open / Roof closed" together with the respective vehicle symbol
depicting the roof completely open/closed for 5 seconds, even if the driver releases the button.
The display cycle is accompanied by a warning sound.
In the event of fault during the roof status screen display cycle, the TFT display displays the fault for a
complete cycle.
At the end of the fault display cycle, the TFT display displays the roof status screen (roof opening / roof
closing) updated to show the current roof position.
In general, in the event of any fault occurring while the roof is starting an opening or closing cycle, the TFT
display will display no screen relative to roof status other than "Roof open" or "Roof closed".
While the roof is moving, the MODE button is disabled (only toggling between trip counters or trip counter
reset are permitted), while the UP / DOWN buttons may be used to adjust the dimming setting.
Roof in standby
If the driver releases the control button with the roof incompletely open or closed, the TFT display displays
the specific message ""Complete roof cycle" together with the relative vehicle symbol depicting the roof
incompletely open/closed.
DO NOT drive the vehicle with the RHT incompletely open or closed.
This screen is displayed until the roof open/close cycle is resumed by pressing the relative control buttons.
Advertisement
