Advertisement
Refitting the complete retractable hard top (RHT assembly)
Tightening torque
Complete RHT assembly - bodyshell
Fastening front seat belt retractor - pretensioner
Front fastener between Tonneau Cover
kinematics and bodyshell
Rear fastener between Tonneau Cover
kinematics and bodyshell
Fastening ECU mounting bracket
Fastening DCT ECU mounting bracket
Before removing any fastener clamps and/or clips in the electronic system and/or hydraulic system,
note the number and position of the components to ensure that they are refitted correctly during
reassembly.
To carry out the following procedure correctly, a hoist and the specific lifting hook are necessary.
FROM Assembly No. 89129
Retrieve the shims (26) from the rear fastener
points, noting the positions and quantities.
The compensator rings for the rear fasteners of
the RHT assembly have been replaced by
the shims (26).
Pretightening torque,
M10x75 screw
M10x75 screw
Screw
M10x75 screw
M8x50 screw
Screw
Screw
Ensure that there is nothing to impede the
operation of the RHT.
After fastening the new RHT assembly to the
lifting hook
nuts and screws (as used to fasten the
removed RHT assembly) use the hydraulic
hoist (OMCN Art. GP05/DE) to align the
assembly onto the relative locator pins on the
bodyshell.
Nm
10 Nm
43 Nm
40 Nm
43 Nm
20 Nm
24 Nm
9 Nm
(AS
107567) using the relative
Class
0
A
A
B
A
B
B
Advertisement
