Advertisement
CAUTION
Danger of accident! At least two operators are required to manually move the components of the RHT roof,
working slowly and in a coordinated fashion.
When handling the tonneau cover manually, the tonneau cover fastener latches may damage the
blocks fastened to the kinematics of the tonneau cover.
The blocks fastened to the kinematics of the tonneau cover protect the flaps. As a result, damage to
the blocks will also result in damage to the flaps.
Before handling the tonneau cover manually, check that the latches fastening the tonneau cover are
correctly released.
Proceeding very carefully and taking particular care not to damage the sensors and relative cables,
manually close the Tonneau Cover completely.
CAUTION
Danger of accident! At least two operators are required to manually move the components of the RHT roof,
working slowly and in a coordinated fashion.
Manually move the Rear Roof shell into its seat.
Attach the clips indicated fastening the electric
cable onto the inner side of the Tonneau
Cover (A).
Refit the sensor (2) on the right hand Rear Roof
shell striker plate, fastened to the Tonneau
Cover (A), tightening the relative fastener
screw.
Refit the sensor (1) on the right hand Tonneau
Cover kinematics (A) by tightening the
relative fastener screw.
Fit a 10 mm wide hex-head wrench in the seat
indicated on both of the Tonneau Cover
kinematics.
On the right hand Tonneau Cover kinematics,
turn the hex-head wrench clockwise to lock
the right hand Tonneau Cover kinematics.
On the left hand Tonneau Cover kinematics, turn
the hex-head wrench counterclockwise to
lock the left hand Tonneau Cover kinematics.
Advertisement
