Advertisement
Refit the external body of the external door handle (
Refit the door panel (
Connect the battery (
Replacing the door lock
Tightening torque
E3.08).
F2.01).
Disconnect the connector (1).
Detach the clip (2) from the internal body (A) of
the external door handle.
Undo the four nuts indicated fastening the
internal body (A) of the external door handle.
Remove the internal body (A) of the external
door handle from the respective seat on the
door subframe, retrieving the relative shim (3).
Detach the Bowden cable (B) from the internal
body (A) of the external door handle.
Replace the internal body (A) of the external
door handle.
Attach the Bowden cable (B) to the new internal
body (A) of the external door handle.
Fit the new internal body (A) of the external door
handle in the respective seat on the door
subframe, installing the relative shim.
Tighten the four nuts indicated fastening the
internal body (A) of the external door handle.
Tightening torque
Nut
Attach the clip (2) to the internal body (A) of the
external door handle.
Connect the connector (1).
E3.08).
Check that the distance between the external
body (C) of the external door handle and the
external surface of the door subframe is 3 ±
0.5 mm.
If the distance is incorrect, loosen the four nuts
fastening the internal body of the external
door handle and add or remove an
appropriate shim to achieve the correct
distance.
Nm
Class
5 Nm
B
Nm
Class
Advertisement
