Advertisement
CAUTION
Danger of accident! At least two operators are required to manually move the components of the RHT roof,
working slowly and in a coordinated fashion.
When handling the tonneau cover manually, the tonneau cover fastener latches may damage the
blocks fastened to the kinematics of the tonneau cover.
The blocks fastened to the kinematics of the tonneau cover protect the flaps. As a result, damage to
the blocks will also result in damage to the flaps.
Before handling the tonneau cover manually, check that the latches fastening the tonneau cover are
correctly released.
Manually close the Tonneau Cover completely.
On the left-hand side of the luggage
compartment, disconnect the connector (1)
from the Tonneau Cover wiring harness.
Pull the cable leading to the Tonneau Cover from
behind the pump out toward the rear bumper.
Remove the ECU mounting bracket (4), by
undoing the two screws indicated, and set
down in the centre of the luggage
compartment.
Undo the two screws (5) fastening the right hand
Tonneau Cover kinematics (A) to the
bodyshell.
Advertisement
