Advertisement
E6.07
Rear screen
Replacing the rear screen
The rear screen is supplied as a spare part with primer already applied. The screen must be used
within 3 months of the date application of the primer. The primer must be reactivated if more than 3
months have elapsed since application.
The Rear Roof shell does not need to be removed from the vehicle in order to replace the rear screen.
Remove the RHT headliner elements (
Remove the Rear Roof shell seal (
Slide the seats forward completely and tip the backrests forward.
Cover all rear trim elements, the rear seats and the Tonneau Cover with protective material.
E6.03).
E6.10).
The following tools are required to remove the
One (Excalibur pneumatic cutter with ESM - 519
For cutting the sealant in the more easily
One (Excalibur 6 pneumatic cutter with Equaliser
For cutting the sealant in deeper, less
A thin metal plate (0.5 mm thick) (C).
To facilitate cutting and protect the bodywork
A face mask (D).
To protect the operator's airways from airborne
Safety eyewear is also recommended to protect
To cut the sealant along the right and left-hand
rear screen glass:
short blade) (A).
accessible locations and for removing
excess sealant on the Tonneau Cover.
Pat. 4955124 long blade) (B).
accessible locations.
from the cutter blade.
fragments of material.
the eyes from flying splinters.
Before cutting, always place the metal in
front of the pneumatic cutter blade, with
the edge of the plate resting against the
bodywork to protect the bodywork against
the blade.
Ensure that there are no obstructions for the
metal plate, as it must be moved together
with the pneumatic cutter while cutting.
sides, place the metal plate (C) between the
bodyshell and the glass panel seal.
Advertisement
