Advertisement
CAUTION
If the RHT open or close cycle is not completed,
the hydraulic system remains pressurised for
up to 5 minutes after the control button is
released. After this period, the system emits a
warning sound to warn the driver and any
persons in the vicinity that the system is no
longer pressurised and that components of the
RHT system may drop without warning.
Move the RHT roof electrically to the
intermediate position, that is until the Rear
Roof shell is over the Front Roof shell.
Remove the rod
(AV
tape (8) to mark the original position of the
two bumpers (M).
Loosen the four dowels indicated fastening the
two bumpers (M).
Move the two bumpers (M) towards the ends of
the rod
(AV
8178).
Tighten the four dowels indicated fastening the
two bumpers (M).
Lock the Rear Roof shell kinematics in the safety
position, fitting the special rod
shown in the image aside.
8178) and use adhesive
(AV
8178) as
Advertisement
