Advertisement
Connect the battery (
Bleed the RHT hydraulic system fluid (
Check the unions on the hydraulic pump for oil leaks.
Refit the luggage compartment trim panels (
Refit the rear left hand trim panel.
Replacing the Tonneau Cover hydraulic cylinders
Before removing any fastener clamps and/or clips in the electronic system and/or hydraulic system,
note the number and position of the components to ensure that they are refitted correctly during
reassembly.
Remove the luggage compartment trim panels (
Remove the rear trim panel only.
Only for the left cylinder. Remove the RHT hydraulic system pump (
Remove the pump without disconnecting it from the system.
Only for the left cylinder. Refit the RHT hydraulic system pump (
Bleed the RHT hydraulic system fluid (
Refit the luggage compartment trim panels (
F2.01).
E6.12).
E6.12).
E4.07).
E4.07).
Release the clips (1).
Remove the cylinder (A).
Before disconnecting the pipes, check that
the hydraulic system is not pressurised.
After the RHT roof open/close button is
released, the hydraulic system remains
pressurised for up to 5 minutes.
Disconnect the pipes (2) releasing the relevant
clips.
Replace the cylinder (A).
Every time the hydraulic cylinder pipes are
detached and refitted the relevant seals
and clip must be replaced.
Take particular care not to damage the pipe
seals and clips, since this could cause oil
leaks.
Connect the pipes (2) fitting the relevant clips.
Fit the gasket correctly on the cylinder then
push the pipe union gently into its relative
seat until it snaps audibly into place.
Position the new cylinder (A).
The incorrect positioning of the cylinder
fastener clips could cause the
detachment and consequent damaging of
the cylinder.
Check always the correct positioning of the
cylinder fastener clips.
Attach the clips (1).
E6.12).
E4.07).
E6.12).
Advertisement
