Advertisement
To prevent damage to the vehicle, ensure
that the Rear Roof shell fastener hooks
are completely and correctly opened
before operating the RHT roof electrically.
Operate the Tonneau Cover to open slightly and
check that the Rear Roof shell striker plate
pin (A) and the Tonneau Cover receiver (C)
are correctly aligned.
While the Tonneau Cover is moving, there must
be no interference between the Rear Roof
shell striker plate pin (A) and the Tonneau
Cover receiver (C).
In the event of misalignment, adjust the lateral
position (along the "Y" axis) of the Tonneau
Cover receiver (C) as follows.
Electrically bring the RHT into the intermediate
position, with the Rear Roof shell over the
Front Roof shell and with the Tonneau Cover
completely opened.
Using a delible marker, draw a reference line on
the receiver rear side (C) of the Tonneau
Cover, along the upper edge in contact with
the relevant mounting bracket.
Advertisement
