Advertisement
Scroll through selections with the UP/DOWN buttons and press the MODE button briefly to enable another
subfunction (if available) or enable the parameter relative to the function selected previously.
Press and hold the MODE button or press the BACK arrow (usually appearing in submenus) to return to the
previous menu level without enabling (or saving) the parameter.
After selecting (with the UP/DOWN buttons) and enabling (by pressing the MODE button briefly) the main
function desired, the individual subfunctions available or the parameters relative to the function selected
previously are shown in a new screen.
When the last level is selected (containing the selectable options), the BACK arrow disappears from the
previous submenu screen and only reappears after a parameter is enabled or after the time-out period for
the submenu itself.
Selecting a parameter only (in "reverse" mode) does not enable it.
Modifications made to any of the parameters selectable in the MENU function will be displayed immediately.
However, as mentioned previously, the MODE button must be pressed briefly to enable the parameter
(with the exception of the Dimming function).
For the dimming function, any modifications to the lighting level made using the UP/DOWN buttons are not
only updated immediately on the display but are also saved (this effect is also achievable by pressing the
MODE button); as a result, in the event of fault occurring during adjustment of the backlighting level, the
lighting level set with the UP/DOWN buttons will be shown on the display.
To return to the MENU screen, use any of the following three methods:
press and hold the MODE button until the main MENU screen is recalled;
press MODE briefly and press the BACK arrow (usually shown in submenus);
do not press the MODE button or the UP/DOWN buttons for at least 10 seconds: in this case any
parameters that have not been enabled will not be memorised.
The "Dimming" (Backlighting), "Twilight sensor sensitivity" and "Buzzer volume" functions are not adjustable
cyclically. When the top bar is reached in the relative bar graph, pressing the UP button again has no
effect and, analogously, when the bottom bar is reached, pressing the DOWN button again has no effect.
On versions with set-up menu available on NQS and absent on NIT:
with the vehicle in motion, only the function "Select speed limit thresholds" is accessible by pressing the
MODE button briefly. After accessing the function, set the desired threshold with the UP/DOWN
buttons, then press MODE to confirm;
all MENU functions are accessible when the vehicle is stationary.
On versions with set-up MENU available on NIT:
when the vehicle is in motion, the functions available from the dashboard will not be displayed;
the following functions can be displayed while the vehicle is stationary: "Dimming", "Select Trip
B", "Speedometer repetition", "Rpm on steer" and "Calibrate TPMS".
The units of measurement selectable (on NIT or NQS, depending on version) are as follows:
Temperature: °C or °F
Pressure: Bar or psi.
Distance: Km or miles
If any event occurs that needs to be displayed while in MENU screen mode, the event display mode depends
on the selected level:
Advertisement
