Advertisement
E6.08
Tonneau Cover kinematics
Removing the Tonneau Cover kinematics
Located at the sides of the luggage compartment, under the trim panels.
The following procedure is for removing the right hand Tonneau Cover kinematics.
The procedure for removing the left hand Tonneau Cover kinematics is essentially the same, with a few
variations.
Disconnect the battery (
Remove the luggage compartment lid (
Remove the Tonneau Cover (
Remove the luggage compartment trim panels (
Remove the rear trim panel.
Remove the RHT hydraulic system pump (
For removing the left hand Tonneau Cover kinematics only.
Replace the Tonneau Cover hydraulic cylinders (
Remove it.
F2.01).
E3.02).
E6.06).
E6.12).
E4.07).
E6.12).
Remove the safety clip (1).
Detach the spring (4) for the right hand flap
control cable (B) from the right hand Tonneau
Cover kinematics.
Detach the clip (5) fastening the right hand flap
control cable (B) from the right hand Tonneau
Cover kinematics.
Undo the front fastener screw (2) for Tonneau
Cover kinematics (A).
Advertisement
