Advertisement
Bring the RHT electrically into the Coupé position, completing the closing cycle.
With the engine running, perform a number of opening and closing cycles to allow the new seal to settle
correctly.
With the RHT in the Coupé position, check that the Front Roof shell seal fits flush with the adjacent
components.
After replacing or removing and refitting the seal, the water tightness test must be carried out.
Replacing the Tonneau Cover seal
After any work on the RHT seals, the water tightness test must be carried out.
The seals are partially fastened by clips which may be broken during removal. New clips are included
with the new spare part.
Move the RHT electrically into the Coupé position.
Open the luggage compartment lid.
Fit the rear section of the Rear Roof shell seal
(A) onto the relative seam.
CAUTION
Danger of accident! At least two operators are
required to manually move the components of
the RHT roof, working slowly and in a
coordinated fashion.
Hold up the Rear Roof shell (1) and remove the
rod
(AV
8178) fitted previously.
Manually move the Rear Roof shell (1) towards
the front of the vehicle, bringing it over the
Front Roof shell.
Advertisement
