Advertisement
Replacing rear storage lock receivers
Remove the luggage compartment trim panels (
Remove the rear trim panel only.
Undo the indicated screws, retrieving the
respective washers.
FROM Assembly No. 94430, remove and
retrieve the bushes.
Remove and retrieve the shim (A).
If necessary, replace the shim (A).
Remove the striker plate (B) and replace.
Fit the new striker plate (B).
Fit the shim (A).
FROM Assembly No. 94430, fit the bushes.
Tighten the indicated screws, repositioning the
washers.
Colour the ends of the striker plate (B).
Apply a piece of rubber-coated paper on the
striker plate seat on the Tonneau Cover
kinematics.
Lower slowly the luggage compartment lid,
without closing it, so as to mark the position
of the striker plate on the piece of rubber-
coated paper.
Lift the luggage compartment lid.
Check that the hook centreline of the Tonneau
Cover kinematics is equidistant from the
indicated marks.
Otherwise, adjust the lateral position of the
striker plate.
Tighten the screws indicated.
Tightening torque
M6x18 screw
E4.07).
Nm
Class
9 Nm
B
Advertisement
