Advertisement
The DATE is displayed as the weekday (e.g. Mon), date and month, without the year.
The Minutes, Hours, Day, Month, Year and time format (12h/24h) may be modified with the buttons via the
relative Menu function (on NIT, with set-up menu available).
In the event of battery reconnection, "- - - - - - - -" is shown in the date area of the display. This will continue
to be displayed until the correct date is set by the driver in the set-up menu (on NIT, with set-up menu
available).
Setting the date:
Enable the "Date Setting" subfunction (from the "Date and Time" screen). A screen is displayed containing
the current date (xx-yy-aaaa). The selection box (with black background) highlights the first parameter
("xx").
Press UP / DOWN to move the selection box to the following parameters:
"xx";
"yy";
"aaaa".
The selected parameter starts flashing. Press UP / DOWN to increase or decrease the active parameter;
Press MODE briefly to confirm the modification (the new value is saved) and exit adjustment mode for
selected parameter;
The selected parameter stops flashing and the selection box remains on the parameter that has just been
modified. Press UP / DOWN to move the selection box to the other parameters and use the same
procedure to adjust the relative value.
Press the BACK arrow to return to the previous MENU level. The BACK arrow is usually only displayed in
submenu functions.
Press and hold MODE to cancel the modification (the previous value is restored), exit the Menu function
and recall the default screen.
After the time-out period for button inactivity, the system exits the Menu function and any modifications made
to the previously flashing parameter and not confirmed with the MODE button are cancelled.
All the parameters described above are cyclically settable. For example, when setting the date, the UP button
may simply be pressed to change from 31 to 1, without having to go back through the values with the
DOWN button.
Storing the "Service start date"
When the vehicle is delivered, the service start date must be stored, from which the counter begins for the
expiry date for the first "Scheduled Maintenance" service.
The parameter is entered using the DEIS diagnostic tester.
Advertisement
