Advertisement
E6.13
Sensors
Replacing sensors HS10-HS11
Before removing any fastener clamps and/or clips in the electronic system and/or hydraulic system,
note the number and position of the components to ensure that they are refitted correctly during
reassembly.
The HS10 sensor is located on the left hand striker plate of the Front Roof Shell.
The HS11 sensor is located on the right hand striker plate of the Front Roof Shell.
Disconnect the battery (
Remove the roof trim panels (
Remove the windscreen cross member trim.
Refit the roof trim panels (
Refit the windscreen cross member trim panel.
Connect the battery (
Replacing sensor PE50
Before removing any fastener clamps and/or clips in the electronic system and/or hydraulic system,
note the number and position of the components to ensure that they are refitted correctly during
reassembly.
The PE50 sensor is located on the left hand kinematics of the Tonneau Cover.
F2.01).
E4.04).
E4.04).
F2.01).
Disconnect the connector (1).
Undo the indicated screw.
Remove the sensor (A) and replace.
Fit the new sensor (A).
Hand tighten the indicated screw.
Connect the connector (1).
Advertisement
