Advertisement
Removing the RHT hydraulic system pump
Before removing any fastener clamps and/or clips in the electronic system and/or hydraulic system,
note the number and position of the components to ensure that they are refitted correctly during
reassembly.
Move the RHT electrically into the Coupé position.
Disconnect the battery (
Remove the luggage compartment trim panels (
Remove the rear left hand trim panel only.
F2.01).
E4.07).
Disconnect the connectors (1) of the hydraulic
pump (A).
Undo the three indicated screws fastening the
hydraulic pump (A) to the left hand Tonneau
Cover kinematics.
Remove the hydraulic pump (A), leaving it
connected to the hydraulic system, from the
relevant seat on the left hand Tonneau Cover
kinematics.
If the hydraulic pump (A) must be replaced,
proceed as follows.
Advertisement
