Advertisement
CAUTION
Danger of accident! At least two operators are required to manually move the components of the RHT roof,
working slowly and in a coordinated fashion.
When handling the tonneau cover manually, the tonneau cover fastener latches may damage the
blocks fastened to the kinematics of the tonneau cover.
The blocks fastened to the kinematics of the tonneau cover protect the flaps. As a result, damage to
the blocks will also result in damage to the flaps.
Before handling the tonneau cover manually, check that the latches fastening the tonneau cover are
correctly released.
Manually open the Tonneau Cover completely.
Remove the sensor (1) from the right hand
Tonneau Cover kinematics (A) by undoing
the relative fastener screw.
Remove the sensor (2) from the right hand Rear
Roof shell striker plate, fastened to the
Tonneau Cover (A), undoing the relative
fastener screw.
Detach the clips indicated fastening the electric
cable from the inner side of the Tonneau
Cover (A).
Detach the clips indicated fastening the electric
cable onto the right outer side of the Tonneau
Cover (A).
Mark the position of the relative right-hand side
kinematics on the Tonneau Cover (A), if the
same component is to be refitted
subsequently.
Undo the outer screw (3) fastening the Tonneau
Cover (A) to the relative right-hand side
kinematics.
Retrieve the relative shims and note the
positions and number of the shims used for
each fastener screw.
Advertisement
