Ferrari California Workshop Manual page 1405

Hide thumbs Also See for California:

Addition of hardeners

(A665, A666, A667)

Application: use a suitable knife or spreader. Apply one or more coats as necessary, allowing 5 –

10 minutes at 20°C between coats. Galvaplast 77 can be used directly on the bare metal.

Dry to sand:

from °C to 10°C

from 10 °C to 20 °C

from °C to 30°C

Dry sanding paper grades:

Overcoating at 20° C:

Primer Deltron D821 – 2K HS Chip Resistant [low VOC Primer Surfacer]

D104 /For detailed information see technical datasheet "104 – Deltron D821"

For detailed information see chapter / section "Sanding and Cleaning"

Hardener and thinner selection: for detailed information see chapter / section "Hardeners and

Mixing Ratio

Number of coats: 2-3

Flash-off between coats at 20°C: 10 – 15 minutes

Flash-off before stoving at 20°C: 10 – 15 minutes

Drying times:

Dustfree at 20°C

Touch dry at 20°C

Through dry at 20°C

Through dry at 60°C

Through dry (IR)

Total dry film build: 70 – 110 µm (tinted: 60 – 90 µm)

from °C to 10°C

from 10 °C to 20 °C

from °C to 30°C

25 – 35 minutes

20 – 30 minutes

15 – 20 minutes

5 – 6 minutes

P80 - P120 - P240

1,5 - 2 hours (tinted: 2 – 2.5 hours)

20 – 25 minutes; tinted: 30

minutes (metal temperature)

2,5 % - 3,0 %

from ,0°C to 2,5°C

from ,5°C to 2,0°C