Advertisement
CAUTION
Danger of accident! At least two operators are required to manually move the components of the RHT roof,
working slowly and in a coordinated fashion.
Manually bring the Front and Rear Roof shells together into the intermediate position, with the Front Roof
shell in its respective seat, in contact with the windscreen cross member, and the Rear Roof shell over
the Front Roof shell.
Remove the protective foam rubber from the
connector (16) and disconnect the connector.
Undo the screw (17) fastening the pretensioner
(18) to the bodyshell.
Secure the pretensioner to the bodyshell to allow
access to the screw fastening the RHT
located below.
Repeat the procedure on the left-hand side.
Remove the pretensioner guard (27), undoing
the two screws indicated.
Disconnect the connector (19) on the roof ECU.
Advertisement
