Advertisement
With cylindrical roller only
Insert the feeler gauge
the left-hand side of the hook (B) and the
striker plate (A).
If the feeler gauge does not fit, the striker plate
must be adjusted again as the lateral
position of the striker plate (along the "Y"
axis) is incorrect.
For "hourglass" roller (NEW SOLUTION)
Visually centre the lateral position (along the "Y"
axis) of the striker plate, so that the vertical
centreline of the roller (2) is perfectly aligned
with vertical centreline of the hook (B).
Pressing upwards by hand, fit the Tonneau
Cover receiver (C) against the striker plate.
Tighten the two screws indicated fastening the
Tonneau Cover receiver (C).
Tightening torque
M6x16 Screw
(AV
8181) again between
Nm
Class
9 Nm
A
Advertisement
