Advertisement
Remove the Tonneau Cover from its seat.
Refitting the Tonneau Cover
Tightening torque
Tonneau Cover - Tonneau Cover kinematics
Before removing any fastener clamps and/or clips in the electronic system and/or hydraulic system,
note the number and position of the components to ensure that they are refitted correctly during
reassembly.
Fit the relative shims in the locations and quantities specified above.
When refitting the same Tonneau Cover, use the original shims.
When fitting a new Tonneau Cover, always use the original spacers as an initial guideline.
Install the Tonneau Cover in its seat.
Mark the position of the relative left-hand side
kinematics on the Tonneau Cover (A), if the
same component is to be refitted
subsequently.
Undo the inner screw (5) fastening the Tonneau
Cover (A) to the relative left-hand side
kinematics.
Retrieve the relative shims and note the
positions and number of the shims used for
each fastener screw.
Mark the position of the relative right-hand side
kinematics on the Tonneau Cover (A), if the
same component is to be refitted
subsequently.
Undo the inner screw (6) fastening the Tonneau
Cover (A) to the relative right-hand side
kinematics.
Retrieve the relative shims and note the
positions and number of the shims used for
each fastener screw.
M8x50 screw
Nm
Class
24 Nm
A
Advertisement
