Advertisement
If necessary, it is possible to accelerate pressing the accelerator pedal: when the pedal is released, the
vehicle will return to the speed that had been stored previously.
- Increase of the stored speed
It may occur in two ways:
pressing the accelerator and then storing the new speed;
or
Turning the ring knob (L) upwards (+).
Every time the ring knob is acted upon, there is an increase in the speed of about 2 Km/h, instead, keeping
the knob turned upwards, the speed varies continuously.
- Reduction of the stored speed
It may occur in two ways:
disengaging the device and later storing the new speed;
or
turning the ring knob (L) downwards (-) till the new speed is reached, which will automatically remain in
storage.
Every time the ring knob is acted upon, there is a reduction in the speed of about 2 Km/h, instead, keeping
the knob turned downwards, the speed varies continuously.
- Deactivating the device
Turn the ring knob (G) on OFF or the ignition key to position 0. The device is also automatically disengaged
pressing the brake pedal.
While driving with the device connected, do not shift gear into neutral.
Removing the steering column switch
The switch is located on the steering column, behind the F1 gearbox shift paddles.
Disconnect the battery (
Remove the steering wheel (
Remove the F1 shift paddles (
F2.01).
E5.09).
E5.12).
Advertisement
