Advertisement
Detach the eyebolt (8) on the right hand EPB Bowden cable (B) from
the fork (9) inside the hub carrier.
Remove the right hand EPB Bowden cable (B) from the respective seat
and replace.
Fit the new right hand EPB Bowden cable (B) in the respective sheath.
Attach the eyebolt (8) on the right hand EPB Bowden cable (B) to the
fork (9) inside the hub carrier.
Tighten the screw (7) fastening the right hand EPB Bowden cable
sheath (B) onto the rear right hand hub carrier.
Tightening torque
Screw
Tighten the nut (6) fastening the ground cable onto the bracket on the
right hand EPB Bowden cable sheath (B).
Tightening torque
Nut
Attach the cable grommet (5) to the bracket on the right hand EPB
Bowden cable sheath (B).
Tighten the nut (4) fastening the right hand EPB Bowden cable (B)
retainer bracket (E).
Left hand EPB Bowden cable
Press on the two indicated fastener tabs and fit the left hand EPB
Bowden cable sheath (D) into the relevant mounting bracket.
Attach the end (3) of the left hand EPB Bowden cable (D) onto the EPB
equaliser (C).
Move the EPB equaliser (C) to the right.
Nm
Class
8 Nm
B
Nm
Class
6 Nm
B
Advertisement
