Honda Accord 2008 Manual page 2645

07/11/02 10:04:56 61TA0000_230_0201
Navigation System
DTC Troubleshooting (cont'd)
DTC 1306: Vehicle Speed Pulse
NOTE:
• Check the vehicle battery condition first.
• Before you troubleshoot, make sure to follow the
general troubleshooting information (see page
23-126).
1. Clear the hard error code (see page 23-136).
2. Turn the ignition switch to LOCK (0), and then start
the engine.
3. Check for the hard error code (see page 23-134).
Is DT C 1306 indicated?
YES − Go to step 4.
NO − Intermittent failure, the system is OK at this
time.
4. Drive the vehicle and watch the VSP signal.
Does the V SP signal change f rom
as you drive?
−
YES Replace the navigation unit (see page 23-240).
NO − Do the symptom troubleshooting for vehicle
position icon constantly leaves road, moves
erratically or is very far from actual position
(see page 23-221).
23-200 23-200
ＴＡ０８ＡＮ１Ｋ７６１０００Ｎ１３０６ＦＡＡＴ００
DTC 1307:
NOTE:
• Check the vehicle battery condition first.
• Check any official Honda service website for more
information about the navigation system.
• Before you troubleshoot, make sure to follow the
general troubleshooting information (see page
23-126).
1. Turn the ignition switch to ON (II).
Is there a DV D error message?
YES
23-230).
NO −
2. Clear the hard error code (see page 23-136).
3. Turn the ignition switch to LOCK (0), then back to
ON (II).
［ ］ 0 to ［ ］ 1 4. Check for the hard error code (see page 23-134).
Is DT C 1307 indicated?
YES
NO −
time.
ＴＡ０８ＡＮ１Ｋ７６１０００Ｎ１３０７ＦＡＡＴ００
DVD Read Error
−
Go to DVD screen error messages (see page
Go to step 2.
− Replace the navigation unit (see page 23-240).
Intermittent failure, the system is OK at this