Honda Accord 2008 Manual page 2642

07/11/02 10:04:17 61TA0000_230_0198
DTC 1302: GPS Receiver Error 1
NOTE:
• Check the vehicle battery condition first.
• Before you troubleshoot, make sure to follow the
general troubleshooting information (see page
23-126).
• Make sure the vehicle is parked outside and away
from buildings.
• Aftermarket electronic devices located near the
navigation unit or GPS antenna can potentially
interfere with the operation of the navigation system.
1. Clear the hard error code (see page 23-136).
2. Turn the ignition switch to LOCK (0), and then back
to ON (II).
3. Check for the hard error code (see page 23-134).
Is DT C 1302 indicated?
YES − Go to step 4.
NO − Intermittent failure, the system is OK at this
time.
4. Turn the ignition switch to LOCK (0).
5. Check for poor connections or loose terminals at
the navigation unit connector E (2P).
6. Clear the hard error code.
7. Turn the ignition switch to LOCK (0), and then back
to ON (II).
8. Check for the hard error code.
Is DT C 1302 indicated?
−
YES Replace the GPS Antenna (see page 23-243).
NO − Intermittent failure, the system is OK at this
time.
ＴＡ０８ＡＮ１Ｋ７６１０００Ｎ１３０２ＦＡＡＴ００
23-197