Vlan Tunnel; Dot1Q Tunnel - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide

VLAN Tunnel

Dot1q Tunnel

This window is used to view and configure the 802.1Q VLAN tunnel's settings.
An 802.1Q tunnel port behaves as an UNI port of a service VLAN. The trunk ports which are tagged
members of the service VLAN behave as the NNI ports of the service VLAN.
Only configure the 802.1Q tunneling Ethernet type on ports that are connected to the provider bridge
network, which receives and transmits the service VLAN tagged frames. If the tunnel Ethernet type is
configured, the specified value will be the TPID in the outer VLAN tag of the transmitted frames out of this
port. The specified TPID is also used to identify the service VLAN tag for the received frame on this port.
To view the following window, click L2 Features > VLAN Tunnel > Dot1q Tunnel, as shown below:
The fields that can be configured in TPID Settings are described below:
Parameter
Inner TPID
Unit
From Port ~ To Port
Outer TPID
Click the Apply button to accept the changes made.
After clicking the Dot1q Tunnel Port Settings tab, the following page will appear.
Figure 5-30 Dot1q Tunnel Settings Window
Description
Enter the inner TPID value here. This value is in the hexadecimal form.
The range is from 0x1 to 0xFFFF. The inner TPID is used to decide if
the ingress packet is C-tagged. The Inner TPID is per system
configurable.
Select the switch's unit ID that will be used here.
Select the switch's port range that will be used here.
Enter the outer TPID value here. This value is in the hexadecimal form.
The range is from 0x1 to 0xFFFF.
113