Config Ipv6 Nd Ns Ipif; Show Ipv6 Nd Ipif System - D-Link DGS-1100-06/ME Cli Reference Manual

Example usage:
To show all neighbor cache entries on the switch:
DGS-1100-06/ME:5# show ipv6 neighbor_cache ipif all static
Command: show ipv6 neighbor_cache ipif all static
IPv6 Address
-------------------
Total Entries: 0
DGS-1100-06/ME:5#

config ipv6 nd ns ipif

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the retrans_time of IPv6 ND neighbor solicitation to be 100:
DGS-1100-06/ME:5#config ipv6 nd ns ipif System retrans_time 100
Command: config ipv6 nd ns ipif System retrans_time 100
Success!
DGS-1100-06/ME:5#

show ipv6 nd ipif System

Purpose
Syntax
Description
Parameters
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
Configures the IPv6 ND neighbor solicitation retransmit time，which
is the time between the retransmission of neighbor solicitation
messages to a neighbor, when resolving the address or when
probing the reachability of a neighbor.
config ipv6 nd ns ipif System retrans_time <integer 1-3600>
This config ipv6 neighbor_cache ipif command is used to
configures the retransmit time of IPv6 ND neighbor solicitation
retrans_time <integer 1 - 3600> – Neighbor solicitation's retransmit
timer in milliseconds. It has the same value as the RA retrans_time
in the config IPv6 ND RA command. If the retrans_time parameter is
configured in one of the commands, the retrans_time value in the
other command will also change so that the values in both
commands are the same. The range if 1 to 3600.
Only Administrator or operator-level users can issue this command.
Used to display information regarding neighbor detection on the
switch.
show ipv6 nd ipif System
This show ipv6 nd ipif System command is used to display
information regarding neighbor detection on the switch.
None.
Link-layer Addr State
---------------------- ---------
203
Interface
---------