Grounding The Switch; Connecting To A Power Source - D-Link DIS-100G-8W Quick Installation Manual

Figure 3 — The switch with the attached wall mounting brackets

Grounding the Switch

Use the following instructions to ground the switch. Please complete these steps before
powering on the switch.
1. Remove the grounding screw from the switch and place the grounding cable lug ring on
top of the grounding screw opening.
2. Insert the grounding screw back into the grounding screw opening and use a
screwdriver to tighten the grounding screw, securing the grounding cable to the switch.
3. Attach the terminal lug ring at the other end of the grounding cable to an appropriate
grounding source.
4. Verify that the connection between the grounding connector on the switch and the
grounding source is secure.
Figure 4 — The grounding screw on the switch

Connecting to a Power Source

The switch can be powered by two power supplies (input range 12 to 58 V DC). Insert the
positive and negative wires (AWG 14-26) into V+ and V- contact on the terminal block and
4