L3 Functions > Ipv4 Routing Table Finder; L3 Functions > Ipv6 Static Route; L3 Functions > Ipv6 Routing Table Finder - D-Link DGS-1210 Series Manual

4 Web-based Switch Configuration
Click the Delete button to remove the entry.
L3 Functions > IPv4 Routing Table Finder
The IPv4 Routing Table Finder page shows the current IPv4 routing table of the Switch. To find a specific
IPv4 route, enter and IPv4 address into the Network Address field and click the Search button.
L3 Functions > IPv6 Static Route
The IPv6 Static Route page allows user to enable and configure the IPv6 route settings.
IPv6 Static Route: Specifies to enable or disable the IPv6 static route feature on the Switch.
Click the Apply button to implement changes made.
IPv6 Address/Prefix Length: Specifies that packets matching that address will be translated.
Nexthop Address: Specifies the corresponding IPv6 address for the next hop gateway address in IPv6
format.
Metric (1-65535): Specifies a metric of the IPv6 interface into the table representing the number of routers
between the Switch and the IPv6 address above. The value ranges between 1 and 65535.
Backup State: Each IP address can only have one primary route, while other routes should be assigned to
the backup state. When the primary route failed, switch will try the backup routes according to the order
learnt by the routing table until route success. The field represents the Backup state that the Static and
Default Route is configured for.
Click Add to create a new IPv6 Static Route.
L3 Functions > IPv6 Routing Table Finder
The IPv6 Routing Table Finder page shows the current Ipv6 routing table of the Switch. To find a specific
Ipv6 route, enter and IPv6 address into the IPv6 Network Address field and click Search.
Figure 4.102 – L3 Functions > IPv4 Routing Table Finder
Figure 4.103 – L3 Functions > IPv6 Static Route
Figure 4.104 – L3 Functions > IPv6 Routing Table Finder
8
8
D-Link Smart Managed Switch User Manual
5
5