Connecting To A Power Source - D-Link DIS-F200G Series Quick Installation Manual

Connecting to a Power Source

The DIS-F200G can be powered using the in-built terminal connector. This allows dual
power inputs, using wires from the power source(s) screwed-in to the terminal connections.
Input voltage is 48 to 56V DC
The Switch offers built-in over current protection and power supply reverse connection
protection.
Using the Terminal Connections
Before proceeding, ensure that all power sources have been disconnected from the
DIS-F200G, and that the power source you are wiring to the DIS-F200G is also disconnected.
Use the following instructions to power the DIS-F200G using the terminal connections:
1. Before continuing, consult the diagram above to decide which wires from the power
source need to connect to which contacts on the terminal block. Note that two power
sources can be used; one inserted into -/+ (labelled PWR1) and the other inserted into
-/+ (labelled PWR2). If you only wish to use one power source, insert the wires into
-/+ (PWR1).
2. Using a flat head screwdriver, loosen the connections in the terminal block by un-screwing
the terminal connections that you wish to use.
3. Insert the wires into the terminal connections and use the screwdriver to tighten the
screws to secure the wires.
4. Re-insert the terminal block into the terminal block socket on the DIS-F200G.
QUICK INSTALLATION GUIDE | DIS-F200G SERIES
5