Calibration Movement Directions For All Axes - ABB IRB 7600 - 500/2.55 Product Manual

Irb 7600 series

Hide thumbs Also See for IRB 7600 - 500/2.55:

Table of Contents

5.4 Calibration movement directions for all axes

When calibrating, the axis must consistently be run towards the calibration position

in the same direction in order to avoid position errors caused by backlash in gears

and so on. Positive directions are shown in the graphic below.

This is normally handled by the robot calibration software.

Calibration movement directions, 6 axes

Note! The graphic shows an IRB 7600. The positive direction is the same for all

6-axis robots, except the positive direction of axis 3 for IRB 6400R, which is in the

opposite direction!

xx0200000089

3HAC022033-001 Revision: M

5 Calibration information

5.4 Calibration movement directions for all axes