Table of Contents
Advertisement
3 Maintenance
3.4.2 Oil change, gearbox axis 1
Continued
Filling, oil, gearbox axis 1
The procedure below details how to fill oil in gearbox, axis 1.
When using the oil exchange equipment, follow the instructions enclosed with the
kit. Art. no. for the kit is specified in
1
2
3
4
5
6
198
Action
WARNING
Handling gearbox oil involves several safety risks.
Before proceeding, please read the safety inform-
ation in the section
WARNING - Safety risks during
work with gearbox lubricants (oil or grease) on
page
54.
DANGER
Turn off all:
•
electric power supply
•
hydraulic pressure supply
•
air pressure supply
to the robot, before entering the robot working
area.
Open the oil plug, filling.
Refill the gearbox with lubricating oil.
The amount of oil to be refilled depends on the
amount previously being drained. The correct oil
level is detailed in section
gearbox axis 1 on page
152.
WARNING
Do not mix oil types! If wrong oil is refilled, the
gearbox must be rinsed as detailed in Technical
reference manual - Lubrication in gearboxes.
Refit the oil plug, filling.
© Copyright 2007-2013 ABB. All rights reserved.
Required equipment on page
Note
Shown in the figure
gearbox on page
Where to find type of oil and total
amount is detailed in
amount of oil in gearboxes on
Inspection, oil level
page
Tightening torque: 24 Nm.
196.
Location of
195.
Type and
194.
3HAC022033-001 Revision: M
Advertisement
Table of Contents
