Table of Contents
Advertisement
Required equipment
The table below specifies the equipment used if damage is detected on the
balancing device. See section
whether to perform maintenance or upgrade!
Equipment, etc.
Maintenance kit,
complete
Maintenance kit,
bearings and seals
Upgrade kit
Securing screw
Toolkit for mainten-
ance
Puller for separator
Separator
Standard toolkit
Other tools and
procedures may be
required. See refer-
ences to these
procedures in the
step-by-step in-
structions below.
3HAC022033-001 Revision: M
Action at detected faults on page 169
Spare part no.
3HAC15834-1
3HAC14962-1
3HAC14965-1
© Copyright 2007-2013 ABB. All rights reserved.
3.3.7 Inspection, balancing device
Art. no.
Note
Includes:
•
•
Includes:
•
•
Includes
•
•
Securing screw in the shaft.
M16 x 180
Locking liquid must be used
when fitting the screw (Loctite
243)!
3HAC15943-1
4552-2 (Bahco)
Used for removing the spher-
ical roller bearings.
4551-C (Bahco)
Used for removing the spher-
ical roller bearings.
3HAC15571-1
Content is defined in section
Standard tools on page
These procedures include
references to the tools re-
quired.
Continues on next page
3 Maintenance
Continued
to determine
complete kit including
the kit with bearings
and seals
instructions for main-
tenance.
kit with bearings, o-
rings and seals only
instructions for main-
tenance.
kit with piston rod,
support shaft etc.
instruction for conver-
sion, 3HAC15864-2.
411.
171
Advertisement
Table of Contents
