Table of Contents
Advertisement
Decommissioning at decommissioning company, balancing device
The instruction below details how to decommission the balancing device. Contact
ABB Robotics for further consultation.
1
2
3
4
5
3HAC022033-001 Revision: M
Action
DANGER
There is stored energy built up by high
tensioned compression springs inside the
balancing device! The device also contains
some grease!
Place the device on a workbench or simil-
ar. Make sure it is clamped in position with
a vice or similar.
Open a hole in the side of the housing as
shown in the figure.
Cut the coils of the three springs inside the
housing as specified below:
•
Outer spring: cut at least five coils!
•
Middle spring: cut at least four coils!
•
Inner spring: cut at least four coils!
Double-check the number of coils cut and
make sure all the tension in the springs is
removed.
© Copyright 2007-2013 ABB. All rights reserved.
6 Decommissioning
6.2 Decommissioning of balancing device
Note
Use a cutting torch. The measurements
shown below are maximum values!
xx0200000082
Use a cutting torch.
Continued
401
Advertisement
Table of Contents
